1.4i not passing raw diseqc commands

[djrh]

Was anyone able to pass raw commands to a diseqc switch?

My setup is DP44 with a 110/119 twin pro lnb connected to port 1/2 respectively and a 129 single pro lnb going to port 3.

If I pass bypass the switch, I am getting signal from all of them. However, I do not get any signal through the switch.

I want to pass raw commands to dp44, but the DVBDream does NOT seems to pass them away. I use DEBUGVIEW and it CONFIRMS that NO commands are sent to the switch.

In DVBDream, my setup is:
Diseqc - none, all 3 satellites added under Port 1
RAW commands - This is where I input the commands
22 - off
Uncommitted port - Disabled

Note that if I set it up as a diseqc switch with sats on ports 1,2,3, I do see commands sent to the switch in DEBUGVIEW.

Anyone?

🌟 Recommended Tools & Services

• Formify.one - Free Online Form Creator (Better than Google Forms). - Create Professional Forms That Match Your Business, Form Builder That Actually Helps You Collect More Responses
• CrispShare - Screenshot Editor That Makes Your Work Look Professional (Without Design Skills). - Make Your Screenshots Stand Out in Crowded Social Feeds
• DVB Dream - Best TV Reception/Record software for your computer DVB add on. - Stop Missing Your Favorite Shows - Record TV Directly to Your PC. Turn Your Computer Into a Professional TV Recorder. Unlock Its Full Potential With Professional TV Software

[genpix]

most probably, wrong format of diseqc command.

btw, you don't need raw commands with DPP44.
though, make sure that 18V is used for bandstacked LNBs (Preferences->General->Performance: it's set to 18V by default, unless you did some changes).