Cannot scan with dvbdream

[dm-_bobjr]

I am having trouble scanning with dvbdream. I have the BDA drivers installed for my twinhan 1020a. When ever I go to scan, the computer freezes and I have to restart. I have tried scanman's bda driver, but I have not had success with that. Whenever I go to scan, it starts for a brief second, then I get the infamous blue screen and the computer restarts. Any help on how to get around this would be greatly appreciated. Thanks

[GrEaTwArRiOr]

mate don't use bda driver use Twinhan WDM driver it comes with your card CD...

i hope its help

regards,
Gr

[TheKrell]

DD 1.4 scans nicely with my 1025 using the Twinhan BDA v.1.2.3.8 (2006. 05) drivers. I believe this is the same driver as your card uses.

I tried the WDM driver once on DD 1.3c, but I don't remember what happened. (Whatever it did, it wasn't better than the 1.2.3.8 driver!) I definitely went back to the BDA driver.

I had the same experience as you using ScanMan's BDA interface, except I didn't get a blue screen. Just the POST all of a sudden.

[dm-_bobjr]

I did the above things and I encounter the other problem I am having. Just for reference, I have the device as the twinhan direct device. I set the lnb to na legacy at 11250000. I go to manual scan and scan 12239 Mhz on echo 7. I get 67% signal and 98% quality. However, the scan will detect no channels. When I do an automatic scan, I get signal, but no channels. Any thoughts?

[dizzymon]

I did the above things and I encounter the other problem I am having. Just for reference, I have the device as the twinhan direct device. I set the lnb to na legacy at 11250000. I go to manual scan and scan 12239 Mhz on echo 7. I get 67% signal and 98% quality. However, the scan will detect no channels. When I do an automatic scan, I get signal, but no channels. Any thoughts?

Reinstall your drivers for your dvb-s card.