DvbDream Community

hy! i believe i have a new generation of the twinhan cards with ci, as no wdm driver and no other bda driver but the one on the cd work with the card. the twinhan app can handle diseq using this bda drivers. but i cant get diseq to work in dvbdream. i tried raw commands but it has no effect. i put these commands in the options:

switch:none
sat1: astra
command: E0 10 38 F0

sat2: hotbird1-7
command: E0 10 38 F4

i also tried : E0 10 38 F0 E0 10 38 F0 or
E0 10 38 F0 E0 10 39 F0, no change.
no matter what, its always astra, even if i leave hotbird in twinhan and quit
twinhan app.
i must say i dont really get what commited means and what the commited switch in the sat options is good for..

thanks a lot!

what i forgot: my card works with
-twinhan dvb app
-dvbdream
-mediaportal

it doesnt work with:
-any version of progdvb (no device. with very old versions i can start the card but get no picture
-altdvb
-sceneo

read this first:
http://www.dvbdream.org/forum/viewtopic.php?t=608

thanks, but i already did. i already mailed twinhan, no response yet. on the twinhan site they say, that the card supports tone switching - how does this work? thx

on the twinhan site they say, that the card supports tone switching - how does this work? thx

If your switch is compatible with ToneBurst, you can select Mini-DiseqC in DD.

tone switch is always greyed out, anyway i have no idea if my lnb is tone compatible, with the other receiver it works by diseq1.2