DvbDream Community

Posted: **Fri Dec 25, 2009 2:53 am**

Hi,

I've got dvbdream setup on a kworld dvb-s 100 with drivers supplied. It all works great in regards to recieving the satelite signal which is good quality. However every hour or so the satelite signal completly drops and I have to wait 30-40 minutes to regain the signal and use the card again.

Has anyone else had this issue? The dish is hooked upto 4 other satelite boxes so its not an issue with that. I'm wondering whether it might be a driver issue.

Any advice/help would be appreciated.

Daniel

Posted: **Fri Dec 25, 2009 9:14 am**

ya you get this problem in drivers supplied .
you have to update the Driver :

http://global.kworld-global.com/main/pr ... &prodid=98

Posted: **Sat Dec 26, 2009 3:43 am**

sos13,

Thanks for your reply. I'll give this a try.

Daniel

Posted: **Sat Dec 26, 2009 3:49 am**

I just checked the drivers installed via the CD and its the same version as on thier site 6.0.1020.4. I take it you had the same problem?

Posted: **Sun Dec 27, 2009 1:41 pm**

The problem was due to me using a one input to two output fplug splitter from one lnb. You can't have different channels only one when using that. I will put another feed from my lnb to the card.

Daniel

Posted: **Mon Dec 28, 2009 8:45 am**

you can NOT use coax-cable splitters with satellite equipment.
Cause coax-cable for satellite reception is a two-way street.

Posted: **Mon Dec 28, 2009 1:03 pm**

may be just changing BDA interface would help .
try bda.dev v2.4
http://www.dvbdream.org/forum/viewtopic.php?t=2405

DvbDream Community

dvbdream and kworld dvb-s 100

dvbdream and kworld dvb-s 100