DvbDream Community

I know there are similar threads on this subject..but I just couldn't find a definative solution..so I'm asking..

How do I hook it all up..
The problem...I have 2 sub boxes running off the dish 1000.2..It just so happens this dish has 3 outputs...

So how do I hook up the 3rd output of 110,119,129 and the other dish 82,91 all to one Skywalker-1...I'm under the impression..I can't plug that 3rd output into the Diseqc..so I need to combine the diseqc and the 3rd output of the 1000.2dish...HOW?


1st dish: Old Legacy Dish 500 to Diseqc ports 1 & 2 aimed at 82 & 91
2nd dish: DISH 1000.2 aimed at 110,119,129

At this point in time, I'm swapping cables.
I can swap cables and get all the channels from each dish.



Video : InterVideo V8.0.6.109 3/20/2007
Audio : InterVideo V8.0.6.109 3/20/2007
VR: VMR9
CoreAVC 1.6.0
Genpix Skywalker-1
KFA GeForce 8600GT 1G mem
Intel Pentium D 3.4GHZ
2GB DDR2-667

Try using a 22Khz switch.

I'm not sure how all this would work...But I'm willing to try

Is this what you are suggesting...

I think it would be more like port 4 22khz on=91 and port 4 22khz off=82.
I'm not sure if it will work but try both infront of the 1000.2's built in diseqc switch or behind in the cable order.

I'm not sure how all this would work...But I'm willing to try

Is this what you are suggesting...

I was thinking more along the lines of what mrnewbie said but I don't see why what you sketched wouldn't work.