DvbDream Community

As of right now im using MyTheatre with LNBs from 110 and 119. Im trying to get this working. I added the echo star (7) and (8,10). I go to the channel scan and all the bars are red ; ;. I tried going into the manual scan and the 2 bars that are their hit 80%+ and then after the scan they disappear ; ;. something im doing wrong?

Im using Azure Wave. AD - SE200 PCI- ex slot

As of right now im using MyTheatre with LNBs from 110 and 119. Im trying to get this working. I added the echo star (7) and (8,10). I go to the channel scan and all the bars are red ; ;. I tried going into the manual scan and the 2 bars that are their hit 80%+ and then after the scan they disappear ; ;. something im doing wrong?

Im using Azure Wave. AD - SE200 PCI- ex slot

Concentrate please and send us your Eureka log ".elf" file if you have a crash and if not a detailed description of your system and configuration of dvbdream

Regards

As of right now im using MyTheatre with LNBs from 110 and 119. Im trying to get this working. I added the echo star (7) and (8,10). I go to the channel scan and all the bars are red ; ;. I tried going into the manual scan and the 2 bars that are their hit 80%+ and then after the scan they disappear ; ;. something im doing wrong? Im using Azure Wave. AD - SE200 PCI- ex slot

AzureWave hasn't been added to supported/tested devices list yet. But you might want to give a try to ScanMan's BDA interface here for better Twinhan support:
http://www.dvbdream.org/forum/viewtopic ... 1&start=15

theres no crash or anything just the signal quality and strength show up and disapear. there was no .elf file so ill try again using the link from above.

theres no crash or anything just the signal quality and strength show up and disapear. there was no .elf file so ill try again using the link from above.

Yeah, I have the same problem, Someone please help. Thank you in advand

I think I am having the same problem with the Twinhan 1027 card. It was working fine (except for diseqc) until I ran the Vista MCE program on the CD. I think it did something to the registry that causes the main drivers to malfunction.

Anybody know what those registry entries were?