DvbDream Community

I am having trouble scanning with dvbdream. I have the BDA drivers installed for my twinhan 1020a. When ever I go to scan, the computer freezes and I have to restart. I have tried scanman's bda driver, but I have not had success with that. Whenever I go to scan, it starts for a brief second, then I get the infamous blue screen and the computer restarts. Any help on how to get around this would be greatly appreciated. Thanks

mate don't use bda driver use Twinhan WDM driver it comes with your card CD...

i hope its help

regards,
Gr

DD 1.4 scans nicely with my 1025 using the Twinhan BDA v.1.2.3.8 (2006. 05) drivers. I believe this is the same driver as your card uses.

I tried the WDM driver once on DD 1.3c, but I don't remember what happened. (Whatever it did, it wasn't better than the 1.2.3.8 driver!) I definitely went back to the BDA driver.

I had the same experience as you using ScanMan's BDA interface, except I didn't get a blue screen. Just the POST all of a sudden.

I did the above things and I encounter the other problem I am having. Just for reference, I have the device as the twinhan direct device. I set the lnb to na legacy at 11250000. I go to manual scan and scan 12239 Mhz on echo 7. I get 67% signal and 98% quality. However, the scan will detect no channels. When I do an automatic scan, I get signal, but no channels. Any thoughts?

I did the above things and I encounter the other problem I am having. Just for reference, I have the device as the twinhan direct device. I set the lnb to na legacy at 11250000. I go to manual scan and scan 12239 Mhz on echo 7. I get 67% signal and 98% quality. However, the scan will detect no channels. When I do an automatic scan, I get signal, but no channels. Any thoughts?

Reinstall your drivers for your dvb-s card.