Page 1 of 1
Stab HH120 no go...
Posted: Sat Nov 03, 2007 12:57 pm
by dfwpilot
...I use all the listed motor types--non will move the dish. It shows the bar moving the motor, but motor still at the same position. I know it is something in a settings that I did wrong, but I can't figure out-what? No switch connected, using only positioner settings--My Theatre moves the dish. Any inputs ?
I can' belive this...
Posted: Mon Nov 05, 2007 5:30 pm
by dfwpilot
... nobody has any input on the issue!? Comon I now there are smart people here!
I tried ScanMan's BDA_ALL -- do not work.
Posted: Tue Nov 06, 2007 1:27 am
by ScanMan
Have you read this:
http://www.dvbdream.org/forum/viewtopic.php?t=1159 ?
What kind of chip the 1027 is using - BT878 ? If yes, you should try a WDM-Driver (2.608a) and then select ThinHan-SDK.
ScanMan
OK!
Posted: Tue Nov 06, 2007 7:20 pm
by dfwpilot
Thank You ! I will try that.
Posted: Fri Nov 09, 2007 8:02 am
by ScanMan
Have you had any kind of success ?
Posted: Sun Feb 03, 2008 1:53 am
by maxxxxel
Hi ScanMan
I also have a Stab HH 120, I used to use ProgDVB and dixie which works fine with my satcard. But i wont use anything other than Dvb Dream
it is the best software out there, stable fast and user friendly
I looked at you link and made the changes you suggested but i still cant get it it to work. I will try some more settings and post my results